Inav: DJI FPV OSD Not working on INAV 2.4.0-RC1 / Matek F722-STD

Created on 30 Jan 2020  路  1Comment  路  Source: iNavFlight/inav

DJI FPV OSD Not working.
I have:
Turn ON MSP on correct uart (4 in my case)
Turn ON OSD and Telemetry,
Downloaded fonts
Put some components on the OSD (the ones working on BF) etc...
Wasn't able to get any OSD in the googles? (latest DJI firmware in both air unit and googles).
The air unit detects the arming normally.

To make sure all is wired and working correctly I loaded BF and did the same as above and got directly the OSD working.

Board: Matek F722-STD

version

INAV/MATEKF722 2.4.0 Jan 22 2020 / 23:48:12 (4a8707e68)

GCC-8.2.1 20181213 (release) [gcc-8-branch revision 267074]

picture CrazyFlutter

Most helpful comment

you don't need to enable MSP, but DJI in peripherals

picture giacomo892 on 30 Jan 2020
❤3

>All comments

you don't need to enable MSP, but DJI in peripherals

giacomo892 picture giacomo892 on 30 Jan 2020
❤3
Was this page helpful?
0 / 5 - 0 ratings

Related issues

ghost picture ghost  路  4Comments
dankvwguy picture dankvwguy  路  4Comments
Jetrell picture Jetrell  路  3Comments
flashez picture flashez  路  4Comments
jasonsmit4 picture jasonsmit4  路  3Comments