Inav: Display problem with OSD

Created on 12 May 2018  路  4Comments  路  Source: iNavFlight/inav

Board and Version

It's an Omnibus F3 (with sd), probably pro version because it has barometer.

version

INAV/OMNIBUS 1.9.1 Apr 21 2018 / 12:53:03 (03a5c1922)

Getting osd problems with some parameters such as:

  • voltage (and cell voltage): displaying weird thing
  • flymode displaying only: 100FS100

DVR: https://www.youtube.com/watch?v=6tVS7ITA2r4

Blackbox logs/Config (.ZIP) where problem occurs

https://pastebin.com/1xHseGdx

If you have any idea of what is occuring ;)

picture flashez

Most helpful comment

Great thx, that really helped me:-) my OSD screen where covered with the letter "V". did the font upload and now it works great, thx again bro:-)

picture rcabuser on 12 May 2018
🎉2

All 4 comments

Just found this similar issue: https://github.com/iNavFlight/inav/issues/3135
Gonna try to update the font

flashez picture flashez on 12 May 2018

Ok so basically this is written on the main page:

Always load OSD fonts when starting using a new board from the configurator OSD tab to avoid artifacts on the video feed.

flashez picture flashez on 12 May 2018
👍1

Great thx, that really helped me:-) my OSD screen where covered with the letter "V". did the font upload and now it works great, thx again bro:-)

rcabuser picture rcabuser on 12 May 2018
🎉2

Just updated the wiki to also mention that you should update the font after upgrading INAV, since most versions contain new characters/symbols in the OSD. I guess we can now close this one.

fiam picture fiam on 13 May 2018
Was this page helpful?
0 / 5 - 0 ratings

Related issues

jasonsmit4 picture jasonsmit4  路  3Comments
dankvwguy picture dankvwguy  路  4Comments
Jetrell picture Jetrell  路  4Comments
digitalentity picture digitalentity  路  4Comments
mrcottonmouth picture mrcottonmouth  路  3Comments