Prusaslicer: Save selected filament profiles to printer profile
Version
2.2.0
Operating system type + version
Windows 10 1909
3D printer brand / version + firmware version (if known)
Prusa MK3S/MMU2S & Prusa Mini
Behavior
When changing between printers, the selected filament profiles are not retained, and defaults to "Prusament PLA"
The selected filament should be saved with the printer profile so they remain the same when you go back to that printer.
It's not much of an issue with a single material machine, but with the MMU it can take some time and is prone to error selecting the correct ones again.
Feature Request
Project File (.3MF) where problem occurs
Not project specific
mrjackson
👍4
>All comments
I'll add that it would be nice if it saved the Print profile I was on as well. Just save the whole state of things when swapping between printer profiles, so when you change back it's all how it was a minute ago.
screwyluie
on 13 Jun 2020
👍5
Was this page helpful?
0 / 5 - 0 ratings
Related issues
TimothyGold
路
4Comments
Bubolz
路
3Comments
yschroeder
路
3Comments
ManuGithubSteam
路
4Comments
karek314
路
4Comments
Most helpful comment
I'll add that it would be nice if it saved the Print profile I was on as well. Just save the whole state of things when swapping between printer profiles, so when you change back it's all how it was a minute ago.