Prusa-firmware: Enable Power Panic in a paused print

[gusdleon]

Hi, I paused a print for a minute of two and then had a blackout for approx 3 minutes and after the blackout the printer turned on normally and forgot the past print so I lost the paused print

Behavior

1. Start a print
2. Pause the print
3. Disconnect the printer, or suffer a blackout

4. Reconnect the printer

   • Results:

     • The printer turns on normally, forgetting the paused print

   • Expected Results

     • The printer will turn on, and display a message of the paused and unfinished print
     • Or, if the blackout was only a couple of seconds only wait to the user to resume the paused print, if the bed is already cool prompt the same message of a common long blackout.

Is this a new feature request?
Yes
or maybe a bug I dont know

Thanks :)

[PavelSindler]

Thank you for feedback. We are aware that this should be improved.

[TheCutter]

Yes, we definitely need this feature. I wonder why power panic doesn't work with paused prints. Should be easier and better to handle then during a print. Please add this! :D

[eliotik]

Hi, happened to me recently. Any update around this feature?

[leptun]

There have been major changes to the PowerPanic implementation in the last week or so. Many changes are planned for the 3.9.0-RC1 which is around the corner. It does not handle a paused print as of yet, but in the near future this is planned to be fixed.

[eliotik]

Thank you for update @leptun :)