Prusa-firmware: option to heat up for filament when unloading
When you press unload filament and the nozel is not hot enough.
You get an error, it would be more user friendly if you would get a question as to, to what temperature would you like to heat up the nozel.
How can i tag this as a feature request ?
erikcramerjr
👍4
All 4 comments
It would also be nice if it extruded 5cm of filament before it begins retracting. That's the only way I've found to reliably avoid getting a bump in the filament that jams the extruder gear.
jcwren
on 25 Feb 2018
👍4
i second both of these suggestions
cnlson
on 25 Feb 2018
Extruding before removing filament is mandatory on my printer too.
sylphio
on 14 Mar 2018
I agree that the ability to preheat and extrude a small amount before unloading would be beneficial.
wsmagee
on 3 Apr 2018
Was this page helpful?
0 / 5 - 0 ratings
Related issues
ulab
路
3Comments
tdiggity
路
5Comments
3d-gussner
路
4Comments
RacingHell
路
4Comments
brettvitaz
路
3Comments
Most helpful comment
It would also be nice if it extruded 5cm of filament before it begins retracting. That's the only way I've found to reliably avoid getting a bump in the filament that jams the extruder gear.