Top klipper issues

Always "move out of range" problem

leungtech picture leungtech·2 Apr 2018·8 Comments

Request to use Filamnet Run Out Sensor

MarcinKnD picture MarcinKnD·21 Mar 2018·13 Comments
👍5

Cable winch kinematics

JonasForssell picture JonasForssell·17 Feb 2018·46 Comments

[Klipper] [Documentation Request] Acceleration Calibration

incomplete issue
Brokengeiger picture Brokengeiger·30 Nov 2020·14 Comments

Speed-dependent extrusion: can it be accounted for?

inactive
dewi-ny-je picture dewi-ny-je·9 Mar 2020·61 Comments

MANY unsupported Gcodes?

mordhau5 picture mordhau5·3 Feb 2020·18 Comments

Stuttering while printing cylinder in vase mode on RPi 3

marcosscriven picture marcosscriven·9 Nov 2019·18 Comments

INIT_TMC does not fully reset TMC2209 but FIRMWARE_RESET does

AshIzat picture AshIzat·26 Aug 2019·21 Comments

Adafruit Grand Central (SAMD51) for RAMPS

jalanjarosz picture jalanjarosz·27 Jul 2019·67 Comments

Klipper v0.7.0 release

KevinOConnor picture KevinOConnor·16 Nov 2018·6 Comments
❤9 👍3 🎉2
 Previous issues
Next issues