Tuya-convert: One way flash Gosund SP111

[uav2608]

Flushed successfully Gosund SP111 with Raspberry Pi 3B with Raspbian Stretch but it worked only one way, I could not undo. Also button does not work any more? Any ideas?

[digiblur]

Did you get it into Tasmota?

[uav2608]

yes, it flashed with Tasmota and web interface works but I cannot use button to on/off and reset wifi settings in Tasmota.

[digiblur]

Did you assign it as a generic template? Then figure out which pin is the button?

[erwill2]

Configuration--> Configure Module-->▼ BlitzWolf SHP (45) and Click Save.

[uav2608]

Honestly, Tasmota is new for me and will work with configuration. Thank you for advice.

[erwill2]

I'm assuming this will work. The Gosund SP111 is listed as compatible with BlitzWolf SHP (45) configuration in the wiki Compatible Devices.

[digiblur]

@uav2608 go to about 8:30 in this video.
https://youtu.be/5Oa27pCHtYo

[merlinschumacher]

After you flashed Tasmota it's not possible to undo the flash via the scripts provided.

Is this still an issue?

[uav2608]

@uav2608 go to about 8:30 in this video.
https://youtu.be/5Oa27pCHtYo

Thank you for the link. I will try to apply it.

[uav2608]

After you flashed Tasmota it's not possible to undo the flash via the scripts provided.

Is this still an issue?

I think it is possible as soon as I can put the device into paring mode. I will configure the modules as proposed above.

[uav2608]

All works perfect with BlitzWolf SHP (45). Did not try with manual way. Thank you for the project.