I found out, that on clean installation of a 5.8.0 (and possibly 5.7.1) version, DHT22 sensor doesn't work, or works rarely (perhaps once in 5-10 minutes). Debug log contains Timeout waiting for start signal low pulse only.
However after rollback to 5.7.0, reset 2, reconfiguration, everything works as expected.
Upgrade from 5.7.0 to 5.8.0 works as expected, DHT22 works.
Tested on Wemos D1 mini and Sonoff Basic.
mr-const
All 4 comments
I have the same issue right now and try to find out what is happening. with weblog 5 I did not see any message related to what you have reported. For me it did not work currently. reset 2 cause a Blocked Loop from webconsole. Therefore I have to figure out what is wrong.
stefanbode
on 10 Oct 2017
Same issue. Finally found this issue after few days of thinking I'm going 馃敥 馃槅
ritschard
on 29 Oct 2017
See #1082
arendst
on 29 Oct 2017
Implemented in master release v5.9.0
arendst
on 30 Oct 2017
Related issues
smadds
路
3Comments
renne
路
3Comments
belidzs
路
3Comments
Vujagig
路
3Comments
j4k3
路
3Comments
Most helpful comment
I have the same issue right now and try to find out what is happening. with weblog 5 I did not see any message related to what you have reported. For me it did not work currently. reset 2 cause a Blocked Loop from webconsole. Therefore I have to figure out what is wrong.