Prusa-firmware: Make the mesh bed levelling speed adjustable
I have a weird issue during the mesh bed leveling sequence. Simply speaking, the movement speeds (or the acceleration/jerk) are too high and I get an unpleasant vibration noise, especially on the Y-axis. As soon as the ninth point is checked and the travel movement speed is reduced both of my MK2.5 printers are running as smooth and usual.
Is there a way to reduce the travel speed during the calibration / MBL process to match the idle movement speeds set e.g. in Slic3r without having to recompile the firmware?
Best wishes,
Martin
MartinMajewski
All 2 comments
I have exactly the same issue. It's weird. First 1st & 2nd point are ok, movement to point 3 is noisy, to point 4 as well, then it's gone to 5 and 6. Movement to 7 is noisy again, to 8 is good and to 9 noisy again. Guess its identical to Martins observation.
Johncoffee2017
on 10 Mar 2019
Same here. Living in an apartment, it's not nice.
thijsdeschildre
on 21 Dec 2020
Related issues
3d-gussner
路
4Comments
austaquio32
路
3Comments
anilrobo90
路
3Comments
sgoll
路
3Comments
stahlfabrik
路
5Comments
Most helpful comment
I have exactly the same issue. It's weird. First 1st & 2nd point are ok, movement to point 3 is noisy, to point 4 as well, then it's gone to 5 and 6. Movement to 7 is noisy again, to 8 is good and to 9 noisy again. Guess its identical to Martins observation.