Prusa-firmware: Polycarbonate Preset Required for Preheating and First Layer Calibration.

[anilrobo90]

Hi,

In Polycarbonate Preheat Profile set bed temperature of 105 Degrees and nozzle temperature of 270 Degrees.

[leptun]

@anilrobo90 I think that @michalxfanta said at some point that custom preheat profiles will come to a future firmware version.

[william14235]

Actually,

you can change the setting for any type of filament

just go to the filament settings option and change the temperature. In the picture, it is 215 for pla, but I could make it 220 or 210. You can also make it different for the first few layers than the rest of the print.

[michalxfanta]

Yes, custom preheats profiles will come.