Prusa-firmware: Save Extruder Calibration M92
It would be nice to be able to save M92 back to the printer after calibration. If this can't be done, then I would request that someone revisit the default value. It would appear that 161.30 is under extruding by 6-8%. M92 E175.32 is what worked for me because I was 8mm short after giving the G1 E100 F100 command.
I'm not saying that I have enough data, but if anyone does, it would be someone at Prusa that could run a few tests with the new printers coming off of the line to get this in the <5% ballpark.
slider162
>All comments
It has been fixed in the 3.0.12-1 version, there just is no download up here for it.
For now, you can download the community modded version, that has these commits included right here: https://github.com/Sebastianv650/Prusa-Firmware
GurliGebis
on 25 Jul 2017
👍3
Was this page helpful?
0 / 5 - 0 ratings
Related issues
3d-gussner
路
4Comments
austaquio32
路
3Comments
sarf2k4
路
3Comments
KarlZeilhofer
路
4Comments
NoNme1
路
4Comments
Most helpful comment
It has been fixed in the 3.0.12-1 version, there just is no download up here for it.
For now, you can download the community modded version, that has these commits included right here: https://github.com/Sebastianv650/Prusa-Firmware