Cura: versie 4.6 and 4.6.1 when using ender 3 pro
With version 4.6.0 there is issue when printing with the Ender 3d pro. Cura is running on a Mac.
With the new version the machine stop printing after , about , a hour printing. Somewhere in the middle of a layer.
By all the different products i did try.
It happens over en over again, at the same spot. It looks to me something in the postprocessor.
Using micro-sd, usb cable or Octoprint it give the same issue.
When i go back to version 4.5.0, there is no problem at all.
COIScois
All 4 comments
This machine profile is not maintained or tested by us.
Here is a list of PRs that have been submitted. We will pull those into a release, and take it on good faith that each profile is properly tested and works well. We don't have Ender 3 equipment so we do no testing from our side.
The best thing to do is to contact the profile author to see if they can make a new PR to fix breaking changes between versions.
mahtDFR
on 11 May 2020
This machine profile is not maintained or tested by us.
That is all nice and dandy, but the issue at hand is not about the ender 3 pro definition. There is nothing in a printer definition that makes the printer stop "after about an hour, somewhere in the middle of a layer".
Something seems to be corrupt in the gcode you are trying to print. Please post a link to a gcode file and we can see if there is something that would explain why the print stops after about an hour.
fieldOfView
on 11 May 2020
I have a few questions before we can debug this.
- Is layer view displaying the whole print?
- Where in the print is it stopping? What does the g-code say at that point in the file?
- Could you supply a project file?
Ghostkeeper
on 12 May 2020
This issue has been automatically closed because there has been no response to our request for more information from the original author. With only the information that is currently in the issue, we don't have enough information to take action. Please reach out if you have or find the answers we need so that we can investigate further.
![no-response[bot] picture](https://avatars2.githubusercontent.com/u/26350515?v=4&s=40)
no-response[bot]
on 19 Jun 2020
Related issues
dstulken
路
3Comments
thopiekar
路
3Comments
Nemernemer
路
3Comments
mnswamp1
路
3Comments
tomoinn
路
3Comments
Most helpful comment
That is all nice and dandy, but the issue at hand is not about the ender 3 pro definition. There is nothing in a printer definition that makes the printer stop "after about an hour, somewhere in the middle of a layer".
Something seems to be corrupt in the gcode you are trying to print. Please post a link to a gcode file and we can see if there is something that would explain why the print stops after about an hour.