Cura: Poor slicing modeling

Created on 13 Mar 2020  路  3Comments  路  Source: Ultimaker/Cura

https://yadi.sk/d/OufBRC8v68UNkQ (Model Link)
https://yadi.sk/i/uC7awodqO7EN7A (Photo slicing)
For a long time I wondered why Simplifiy3d prints better than 小ura, until I looked at what our favorite slicer slices. With any standard settings, I get errors on the surface. Maybe I don鈥檛 know any settings? Or is the slicer corrupted? Model checked and printed in s3d without these artifact. Perhaps 小ura is so cool that he makes predictions where my printer will give a mechanical error? ;)

Engine Bug
Source
picture jornada812

All 3 comments

Try disabling "compensate wall overlaps". See if that helps.

CCS86 picture CCS86 on 15 Mar 2020

I'm not quite sure it's compensate wall overlaps. It's looking an aweful lot like artefacts caused by the "maximum resolution" setting. You might want to look at that setting too.

nallath picture nallath on 16 Mar 2020
👍1

This is the issue that triggered research into a fix that eventually led to this PR: https://github.com/Ultimaker/CuraEngine/pull/1214

Ghostkeeper picture Ghostkeeper on 17 Mar 2020
👍1
Was this page helpful?
0 / 5 - 0 ratings

Related issues

mubarak111nsu picture mubarak111nsu  路  3Comments
Liger0 picture Liger0  路  3Comments
StanislavJochman picture StanislavJochman  路  3Comments
muhammadelmogy picture muhammadelmogy  路  3Comments
dstulken picture dstulken  路  3Comments