Tasmota: h801 all leds flash on when applying power

Created on 27 Jul 2017 · 6Comments · Source: arendst/Tasmota

hi,

I take away the voltage of the h801 controller when i'm not using it, but when I apply voltage, the leds flash on for like 50 ms. This looks like somebody is flashing with a camera, because my led strips are RGBWA all in one. Can this be disabled somehow?

thx

stale

Source

jormus

Most helpful comment

I guess not as it's the result of initial power up of the esp8266 having set the pwm ports to a default stae before the firmware kicks in.

Same happens on my BN-SZ ceiling led. Just leave the power on and turn the led off.

arendst on 28 Jul 2017

👍2

All 6 comments

I guess not as it's the result of initial power up of the esp8266 having set the pwm ports to a default stae before the firmware kicks in.

Same happens on my BN-SZ ceiling led. Just leave the power on and turn the led off.

arendst on 28 Jul 2017

👍2

This issue has been automatically marked as stale because it has not had recent activity. It will be closed if no further activity occurs. Thank you for your contributions.

stale[bot] on 23 Apr 2018

This issue will be auto-closed because there hasn't been any activity for a few months. Feel free to open a new one if you still experience this problem.

stale[bot] on 8 May 2018

I have the same issue. I don't think it is due to a HW problem, because when I leave the original firmware and configure with ewelink, it doesn't blink on powering up.