Qmk_firmware: DZ60: Board Initializes to Wrong Layer

[bhilburn]

When I first plug in / power in my DZ60, it always starts in the third of my four layers. I'm not sure why it does this, and I can't seem to figure out how to actually just make it start in the base layer.

System Information

• Keyboard: DZ60
  
  
  
  • Revision (if applicable): USB-C
  
  
• Operating System: Linux
• avr-gcc version: 6.3.0
  
• arm gcc version: 7.1.0
  
• QMK Firmware version: 0.6.256
  
• Any keyboard related software installed? No
  
  
  
  • [ ] Auto Hot Key
  
  
  • [ ] Karabiner
  
  
  • [ ] Other
  
  

Additional context

You can find my code here:
my keymap.c

[pelrun]

Have you tried resetting the eeprom using QMK Toolbox?

[bhilburn]

I have not tried resetting the eeprom, no. I'll give that a go - thanks for
the suggestion!

Sent from my mobile.

On Sat, Jan 26, 2019, 21:08 James Churchill <[email protected] wrote:

Have you tried resetting the eeprom using QMK Toolbox?

—
You are receiving this because you authored the thread.
Reply to this email directly, view it on GitHub
https://github.com/qmk/qmk_firmware/issues/4958#issuecomment-457882560,
or mute the thread
https://github.com/notifications/unsubscribe-auth/AAiw42zCsAxEU3pFDUKZciKvdHHLQciLks5vHQodgaJpZM4aUfjF
.

[drashna]

Did that fix the issue?

[bhilburn]

I actually haven't gotten a chance to try it yet, actually. I'll update this issue as soon as I do, hopefully this weekend.

[germ]

Just had a customer have this exact problem, resetting the EEPROM from toolbox was the correct answer.

[bhilburn]

Can confirm it fixed it for me, too! Closing this one out =)