Minikube: Minikube unable to start using the xhyve driver
馃槃 minikube v1.4.0 on Darwin 10.14.6
馃挘 The driver 'xhyve' is not supported on darwin
C02Y83T8JGH5:manifests C5287199$ minikube start
馃槃 minikube v1.4.0 on Darwin 10.14.6
馃敟 Creating virtualbox VM (CPUs=2, Memory=2000MB, Disk=20000MB) ...
馃攧 Retriable failure: create: precreate: exit status 126
馃敟 Creating virtualbox VM (CPUs=2, Memory=2000MB, Disk=20000MB) ...
馃攧 Retriable failure: create: precreate: exit status 126
馃敟 Creating virtualbox VM (CPUs=2, Memory=2000MB, Disk=20000MB) ...
馃攧 Retriable failure: create: precreate: exit status 126
馃敟 Creating virtualbox VM (CPUs=2, Memory=2000MB, Disk=20000MB) ...
馃攧 Retriable failure: create: precreate: exit status 126
bala0409
All 2 comments
The "xhyve" driver has been deprecated and removed in minikube v1.3.0 (exchanged for hyperkit), so you will need to switch to another driver (and recreate the VM). This can be done using minikube config set vm-driver hyperkit.
afbjorklund
on 27 Sep 2019
I assume, you can close it. It's expected behavior for "xhyve" driver. @afbjorklund
AndrewGumenyuk
on 1 Nov 2019
Related issues
jroucheton
路
3Comments
alber70g
路
3Comments
RaeesBhatti
路
3Comments
tstromberg
路
3Comments
mdkess
路
3Comments
Most helpful comment
The "xhyve" driver has been deprecated and removed in minikube v1.3.0 (exchanged for hyperkit), so you will need to switch to another driver (and recreate the VM). This can be done using
minikube config set vm-driver hyperkit.