Ironos: Incorrect power meter display v2.06-RC5
- I'm submitting a ...
- [x] Bug report
The power display fluctuates around one watt when warming up. When the temperature reaches, the indicator shows zero or a very low value.
Powered at 19 Volts.
NeoVerter
All 6 comments
Same problem here with an TS80.
Using a Keweisi KWS-MX18 for power supply monitoring an a charmast W2009P powerbank wich is able to supply 12V. The TS80 is also set to this value.
First the TS80 is only using 9V, this is something I can see on the powerbank, the KWS and the iron itself.
Second when heating up, the iron is telling me it uses about 30W, the KWS-MX18 is telling me it only uses about 18W. After the heat of 450掳 is reached, it will not stop heating and hits over 480掳, the iron is telling me its using between 0W-90W, the KWS is telling about 7W. After some seconds it will slowly decrease the temp around the 450掳.
TheUntouchable
on 19 Jul 2019
Same, TS100 never shows over 3.1W even in boost mode. 24V 6A notebook style AC adaptor.
CutterSlade001
on 22 Jul 2019
Nothing new on that? I will go back to the old firmware es the iron starts smelling after it got over 480掳.. :(
TheUntouchable
on 2 Aug 2019
It's purely an aesthetic issue with me forgetting to change a divisor before the number is shown. It doesn't affect operation.
The irons tip is only rated to 400C for main use, and 450C is pushing it to the limit.
You shouldnt use the tip above 380C for prolonged use.
Ralim
on 2 Aug 2019
This should have been fixed in the latest release
Ralim
on 29 Dec 2019
2.07: Just checked it out. Can confirm, it's working again, thanks for your hard work! <3
CutterSlade001
on 7 Jan 2020
Related issues
Dag0d
路
5Comments
Fluvance
路
3Comments
federicodilo
路
5Comments
jlevy-dev
路
5Comments
Rocker7837
路
5Comments
Most helpful comment
Same problem here with an TS80.
Using a Keweisi KWS-MX18 for power supply monitoring an a charmast W2009P powerbank wich is able to supply 12V. The TS80 is also set to this value.
First the TS80 is only using 9V, this is something I can see on the powerbank, the KWS and the iron itself.
Second when heating up, the iron is telling me it uses about 30W, the KWS-MX18 is telling me it only uses about 18W. After the heat of 450掳 is reached, it will not stop heating and hits over 480掳, the iron is telling me its using between 0W-90W, the KWS is telling about 7W. After some seconds it will slowly decrease the temp around the 450掳.