Ems-esp: No Access Point called ems-esp

[sand3rk]

Question
Is it correct that after flashing EMS-ESP the software does _not_ go in Access Point mode with a SSID called ems-esp, if I _don't_ have a interface board connected?

I'm still waiting for my interface board to arrive, but thought I test out the software.

Screenshots
https://imgur.com/xWkJ1bT

Device information
Chip is ESP32D0WDQ6 (revision 1)
Features: WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None
Crystal is 40MHz

Additional context
I tried version 1.9.4 and 1.9.3, replugged in to usb port after flashing.

[bbqkees]

You are flashing a bin file for the ESP8266 on an ESP32.
EMS-ESP runs on a ESP8266.

[sand3rk]

Ok, I thought a ESP32 works too. I will wait for the ESP8266 to arrive. Thanks