Cura: SOVOL SV02 printer problem

[Fabdu57]

Hello,

I have two printers at home : SOVOL SV02 and CREALITY Ender 3 V2.
I use on both exactly same profile : Creality V2 Figurine.zip

Strangely, when i prepare my item with SV02 profile, i have a lot of defect :

If i make the same item with Ender 3 printer and profile, no problem.
In attachment both 3.m files :
Item.zip

I'm not sure, but i think that problem is Cura with SV02 printer.

Can you help me please ?

[nallath]

The Sovol 2 has coasting enabled by default. The Creality 3 does not.

[Fabdu57]

So how can i do in this case ?

[nallath]

You click the checkmark in the setting list next to "Enable coasting"

[Fabdu57]

Like if i enable it, i have still the problem

[nallath]

You can also try to change the maximum resolution / maximum deviation setting.

[Fabdu57]

I am sorry but i don't understand.
You close my topic and propose me some ideas.

As i say, on printer creality i don't have this problem.
Is the slicer is the same for ender 3 pro and SV02 in Cura ?

[Fabdu57]

Finaly i find the solution...
Your firs proposal was good : activation of coasting, then modify "coasting volume" and put 0 instead of 0.06mm². Then my problem dissapear.

[fieldOfView]

Like if i enable it, i have still the problem

What @nallath meant was that by default the Sovol 2 is configured with Coasting enabled. If you turn it off in the sidebar (ie: don't HIDE the setting, but uncheck the checkbox in the sidebar), the defects will probably disappear.

[fieldOfView]

modify "coasting volume" and put 0

That is effectively the same as unchecking the "Enable coasting" checkbox.

[Fabdu57]

I don't understand.
After make "0" no holes.
If i put again 0.064mm², no hole again.

For me; slicer for SV02 have a problem...

[Fabdu57]

Problem is solve.
Thanks to nallath and fieldOfView for your help