Today I noticed that Cura 2.1.2 is not using, when saving the G-code, as default the path of the STL opened.
Can this be fixed?
Now you have to click many times before you can save.
RoRi3D
All 4 comments
The expected behaviour is not that it should take the directory from where the STL was loaded, but that it should remember the directory you last saved anything to.
I've recently seen that this doesn't seem to happen, but I figured that might be a relic from me running Cura from source (since it takes the directory I'm calling Python from instead). Does it properly remember the last-used directory on actual builds?
Ghostkeeper
on 11 Jul 2016
Nope it doesn't. It used to be that way but I was told to change this. The behavior now is that it _always_ looks in the home directory.
nallath
on 11 Jul 2016
We have put this on the planning again to reinstate the remembering of save/load locations.
Ghostkeeper
on 12 Jul 2016
I think this has already been fixed.
nallath
on 27 Jul 2017
Related issues
tomoinn
路
3Comments
jellewie
路
3Comments
timherrm
路
3Comments
mnswamp1
路
3Comments
probonopd
路
3Comments
Most helpful comment
We have put this on the planning again to reinstate the remembering of save/load locations.