Airsim: Failsafe enabled: no RC and no offboard. Failsafe mode enabled

Created on 5 May 2017  路  1Comment  路  Source: microsoft/AirSim

When I run Droneshell demo and type a command such as 'MoveToZ' , it always causes a problem that the drone make self adjustment and then lose control flying indiscriminately. Is there any problem with my settings? Thank you.
2222

picture lxgen

Most helpful comment

Try setting this property on your PX4: "NAV_RCL_ACT=0", this will stop the fail safe behavior due to having no RC.

picture lovettchris on 9 May 2017
👍4

>All comments

Try setting this property on your PX4: "NAV_RCL_ACT=0", this will stop the fail safe behavior due to having no RC.

lovettchris picture lovettchris on 9 May 2017
👍4
Was this page helpful?
0 / 5 - 0 ratings

Related issues

JenaEmz picture JenaEmz  路  3Comments
ShukuiZhang picture ShukuiZhang  路  4Comments
M-Kasem picture M-Kasem  路  3Comments
zywOwO picture zywOwO  路  3Comments
vinbo picture vinbo  路  4Comments